RAMSET T3SS Betriebsanleitung PDF herunterladen (Seite 19)

SERVICING / TROUBLESHOOTING

SYMPTOM POSSIBLE PROBLEMS SERVICE

Preparing Tool for Operation—Battery/Charger Problems

— Battery Cell does not — Inoperative indicator —

Try Battery Cell in tool after 3 hours

appear to accept lights on charger on charge cycle. If tool LED is

charge. Green charger green, charger lights are not

light does not come on working properly. Replace charger,

or monitor charging time to ensure

Battery Cell has adequate time for

recharging. It’s normal for Battery

to feel warm after properly charging.

— Battery Cell damaged — Replace Battery Cell

or cycle life exhausted

— Damaged charger — Discontinue use immediately and

unplug from power source. Replace

charger and tag or dispose of

charger to prevent accidental

reuse or connection to power source.

— Flashing lights on — Damaged Battery Cell — Replace Battery

charger base unit — Battery Completely — Allow battery to charge for

Drained 5 minutes

Normal Stage of Operation

— Fan does not run — Battery in off position — Fully insert Battery

—tool LED is off

— Battery Cell is — Charge Battery Cell according to

not charged Operating Manual.

— Battery terminals or — Clean Battery Cell terminals.

battery contacts are Battery Cell contacts as required.

oily, dirty, or corroded

— Fan does not run, — Battery Cell is — Charge Battery Cell

or runs slower than discharged

normal—tool LED is red

— Fan does not run, — Possible electronics — Remove, reinsert the Battery

tool LED flashes error Contact Authorized Ramset

red/green Distributor Sales Representative

for service.

Pre-Combustion/Combustion Stage of Operation

— Work Contacting —Work Contacting — Remove and inspect Work Contact

Element does not Element is bent, or Element. Repair or replace Work

depress fully—tool build-up of debris in Contact Element as required.

does not operate nose restricts operation

— O-Ring pinched — Contact Authorized Ramset

Distributor Sales Representative

for service.

(For T3 Magazine tool only) — Tool is out of fasteners — Add fastener strip

— Tool will not cycle—fan — Fuel Cell is empty — Replace Fuel Cell

runs, LED is green

— Spark does not occur. — Contact Authorized Ramset

Distributor Sales Representative

for service.

1 2 ... 14 15 16 17 18 19 20 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare

RAMSET T3SS Betriebsanleitung Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge RAMSET T3SS