RAMSET D45 Betriebsanleitung PDF herunterladen (Seite 11)

TROUBLESHOOTING

REFER TO PARTS SCHEMATIC FOR PROPER ASSEMBLY OF PARTS

- Overdriving of fasteners - Excessive power - Change to next lower

power level load disc

color and number.

- Soft base material - Check base material

(see page 3)

- Tool fails to fire - Failure to depress - See “ Tool does not

completely completely depress”

- Excessive dirt buildup - After following misfire

on breech face not allow- procedure, check firing

ing proper penetration of pin indentation on load.

firing pin Clean breech face

- Firing pin and/or breech - Replace damaged parts

damaged

- Tool does not completely - Misassembled or damaged - Check all parts in the

depress parts receiver for damage or

improper assembly.

- Reduction or loss of - Piston not being returned - Barrel must be pulled

power to the full rear position completely open to

properly reset the

piston.

- Worn or damaged piston or - Replace worn

piston ring or damaged parts

- Worn or broken pawls - Replace pawls

- Tool cannot be cocked or - Excessive dirt buildup - Clean tool thoroughly

opened

- Damaged or bent piston - Replace piston

- Broken or damaged parts - Tag tool with warning

“Defectine- Do Not Use”

Place in a locked con-

tainer and contact your

ITW Ramset/Red Head

representative for

service.

- Failure to index disc - Disc not inserted in tool - Check load disc

correctly or is damaged Properly dispose of

damaged disc (see

page 6)

- Damaged indexing - Contact your ITW

mechanism Ramset/Red Head

distributor for

assistance.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

RAMSET D45 Betriebsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge RAMSET D45