RAMSET SA270 Betriebsanleitung PDF herunterladen (Seite 10)

4. Hold the tool perpendicular (90°) to

the work surface with both hands and

press firmly to fully depress the tool.

Maintain firm downward pressure on

the tool with both hands and pull the

trigger to drive the fastener. DO NOT

DEPRESS THE TOOL AGAINST

ANYTHING OTHER THAN THE

INTENDED

WORK SURFACE. Holding

the tool firmly

in place will produce

more consistent fastening quality and

minimize tool wear or damage.

5. After making the fastening, fully open

and then close the tool to the semi-

closed position. This resets the piston

and indexes a new load into place for

the next fastening.

6. Insert another fastener in the muzzle

end of the tool as before and the tool

is ready for the next fastening. Keep

your finger off of the trigger until the

tool is in position to drive the fastener.

7. To remove a used or partially used

strip load from the tool, pull the strip

out from the top of the tool. Do not

try to remove the strip by pulling it out

from the bottom of the handle. NEVER

try to remove a jammed or stuck

load strip. Should a “jammed” load

strip occur, call your local Authorized

Ramset Distributor for technical

assistance.

Power Adjust

The power level on the SA270 may be

adjusted for varying base materials by

turning the power adjust wheel located at

the rear of the tool.

TOOL OPERATING INSTRUCTIONS

TOOL OPERATING INSTRUCTIONS

10

HOLD THE TOOL FIRMLY

AND PERPENDICULAR TO THE

WORK SURFACE

90°

FULLY OPEN AND CLOSE TOOL TO THE

SEMI-CLOSED POSITION

Keep hands away

from muzzle

INSERT THE NEXT FASTENER

REMOVE THE LOAD STRIP ONLY FROM

THE TOP OF THE TOOL

POWERPOWERPOWERPOWERPOWERPOWERPOWERPOWER

POWER

+ INCREASE

- DECREASE

POWER LEVEL ADJUSTMENT

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare