RAMSET XT540 Betriebsanleitung PDF herunterladen (Seite 14)

INSPECTION / TOOL MAINTENANCE

14

INSPECTION / TOOL MAINTENANCE

1. Ensure that no power loads are loaded

in the tool. Remove the power load strip

by pulling it upwards out of the tool.

2. Hold the tool vertical with the fastener

guide/ magazine pointing upwards.

Unscrew the fastener guide/magazine.

If this is too difficult by hand, use pliers.

3.

Take out the piston assembly (piston,

piston return spring and buffer).

4. Push the barrel downwards and

unscrew the collar surrounding the

barrel. Remove the barrel assembly.

5. Check the length of the return spring

using the measuring points located on

the top of the tool housing. This check

should be made every 3,000 shots.

6. CHECK:

•

The piston tip - replace if it is damaged.

•Thestraightnessofthepiston–ifitis

not straight, replace it.

•Thepistonbuffer-replaceifitisworn

or less than 3/16” thick.

7. Using wire brushes, thoroughly clean all

internal and external steel surfaces of

any carbon buildup.

It is important to clean a Powder Acuated

Tool weekly. The carbon build up from the

explosive

material can decrease the effective-

ness of the tool and if not removed, cause long

term damage

to the tool.

CAUTION: The tool may become hot during

operation. Tool maintenance should be

performed when the tool has cooled down

to avoid the possibility of receiving burns to

hands.

OK!

CHANGE

STEP 2

STEP 3

STEP 4

STEP 5

1 2 ... 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare