RAMSET D45 Bedienungsanleitung PDF herunterladen (Seite 10)

2.0 Operation and Maintenance

2.1 General Operating Instructions

-Warning- Only certified operators familiar with the

Ramset tool should be performing

assembly and/or operation.

1. Confirm that no powder load disk is in the Ramset D45A tool. Set up the type for the required

mark. Pull out the retaining pin and install the required type. Reinstall the retaining pin to hold

type in holder.

-Warning- Always wear proper eye and hearing

protection when operating this tool.

2. Install a powder load disk in the Ramset D45A tool.

3. Slide the Portamark attachment fully out of the Ramset D45A tool so that the piston is cocked

and in the firing position.

Barrel in extended position. This

cocks the tool.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Keine Kommentare

RAMSET D45 Bedienungsanleitung Seite 10