RAMSET D45 Bedienungsanleitung PDF herunterladen (Seite 8)

2. Slide the Portamark barrel retention collar (shown below) onto the barrel. Note

that the tapered end of the collar faces the Portamark holder and away from the

Ramset tool.

3. Slide the barrel into the Ramset D45A tool. The barrel alignment rod that

protrudes from the barrel must align with a hole inside the Ramset tool. (If you

have a “D45” instead of the “D45A” – you must remove the barrel alignment rod

by sawing it off flush.) Install the two barrel retention pawls. While holding the

barrel in the tool, thread the barrel retention collar onto tool.

Reinstalling The Pawls

Portamark Holder Portamark Barrel Portamark Barrel Retention Collar

Barrel Alignment Rod

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

Keine Kommentare

RAMSET D45 Bedienungsanleitung Seite 8