RAMSET D45 Bedienungsanleitung PDF herunterladen (Seite 11)

4. Press the Portamark attachment firmly against the marking surface. This should cause the

safety pawls to spread, allowing the trigger to be pulled and the mark to be generated.

-Note- MECCO Marking & Traceability

recommends a detailed safety procedure

be established for the operation and

storage of the tool and powder loads.

MECCO Marking & Traceability accepts no

responsibility for the improper use of the

tool.

5. To mark additional pieces, let the Portamark attachment slide fully out of the Ramset tool so

that the piston cocks. Press the Portamark attachment firmly against the marking surface and

pull the trigger.

6. When marking is complete, remove the powder load disk from the Ramset D45A tool and

follow the tool cleaning instructions. Store tool and loads in a proper place.

Pawls are not spread, preventing the tool

from firing. The type is not squarely

aligned on the part.

Pawls are spread. This allows the tool to

be completely depressed, and firing can

occur.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Keine Kommentare

RAMSET D45 Bedienungsanleitung Seite 11